Maintenance - Ryobi P717 Manual Del Operador

OVER TEMPERATURE PROTECTION
If overheating occurs, the light will attempt to cool itself by
dimming.
If dimming does not cool the light sufficiently, it will shut off.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or
performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION

MAINTENANCE

NOTE: ILLUSTRATIONS START ON PAGE 6
As soon as the unit reaches normal operating temperature,
it can be turned on again. If it shuts off, allow approximately
10 minutes of cool-down time before attempting to resume
operation.
NOTICE:
The LEDs cannot be replaced. Any attempt to replace
the LEDs may damage the spotlight.
CHANGING THE FUSE
See Figure 4, page 6.
The 12 Volt adaptor contains a 250 Volt, 8 Amp, 5 x 20 mm
fuse to protect the adaptor and charger from unexpected
power surges.
To replace the fuse:
 Unscrew the fuse cap on the end of the 12 Volt adaptor.
 Install the replacement fuse. If the spring comes out, be
sure to reinsert it before installing the new fuse.
 Thread the fuse cap back onto the adaptor. Tighten se-
curely.
STORAGE
Store indoors in a dry, locked up place—out of the reach
of children with the battery pack removed and power cord
disconnected. Keep away from corrosive agents such as
garden chemicals and de-icing salts.
5 — English