Features; Assembly; Operation - Ryobi P3180 Manual Del Operador

PRODUCT SPECIFICATIONS
Dual Power Source .......................................18 Volt Battery
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is suf-
ficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Risk of fire. Never position heater at a downward angle
or towards combustible materials. This heater must be
located away from combustible surfaces by no less than
24 inches from rear and sides of heater and 72 inches from
above and front outlet of heater. Heater must be placed on
a level surface and the flow of combustion and ventilation
air not be obstructed.
APPLICATIONS
You may use this tool for the purpose listed below:
 General heating of outdoor spaces and most construction
sites with adequate ventilation

FEATURES

or 120 Volts, AC only, 60Hz

ASSEMBLY

OPERATION

Output .............................................................. 15,000 BTU
Fuel Source ..................................... Propane (not included)
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
NOTICE:
This product is designed to be powered by either a RYOBI
One+™ 18V battery pack (DC mode) or by electric power
(AC mode). Either power source can be used by installing
an approved battery pack or power cord into the product
as described in this manual.
USING PROPANE (LIQUID PROPANE ALSO
CALLED LIQUID PETROLEUM)
Propane cylinders used with this heater must be constructed
and marked in accordance with the Specifications for LP Gas
Cylinders of the U.S. Department of Transporation (D.O.T.) or
the National Standard of Canada, CAN/CSA-B339, Cylinders,
Spheres, and Tubes for Transportation of Dangerous Goods;
and Commission.
Propane is highly flammable and may ignite unexpectedly
when mixed with air.
INSTALLING AND TESTING A 1 LB. PROPANE
CYLINDER (NOT INCLUDED)
See Figures 1 - 3, pages 12 - 13.
DANGER:
DO NOT smoke or use an open flame during leak test. If
a leak is present, the gas could ignite and result in seri-
ous personal injury.
7 - English