Auto Shut Off - Ryobi P3180 Manual Del Operador

 When the LED displays a solid green, release the gas
valve button and the burner should remain lit.
NOTE: If the burner doesn't remain lit, wait 30 seconds
and repeat the starting steps, making sure the gas valve
button is pressed immediately after it begins flashing
green and held until the LED displays a solid green to
lock the gas valve in the on position. If it still fails to ignite,
check fuel level in the propane cylinder.
NOTE: A solid red LED indicates a fault condition. Contact
Customer Service for assistance.
To stop:
 Press the on/off button. The heater will automatically shut
down.
 Remove the propane cylinder and replace the cap on the
cylinder.
 Remove the power cord or battery from the unit.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 11 AFTER FRENCH
AND SPANISH LANGUAGE SECTIONS. ILLUSTRATIONS START ON PAGE 12.
OPERATION

AUTO SHUT OFF

The unit will automatically shut off during any of the follow-
ing conditions:
 Flame out — If the propane tank is empty or the flame is
accidently extinguished.
 Over temperature — If the flow of air becomes blocked
or the temperature inside the unit is too high, the unit will
automatically shut off and the LED will flash orange.
NOTE: A flashing orange LED indicates an operation error.
Make sure air flow is not restricted. Turn off the unit and
restart.
 Low voltage — such as a power outage or a low battery.
STORAGE
Always remove the propane cylinder, battery pack, and/or
power cord from the unit when storing. Always store the
unit indoors.
9 - English