Garant 23 7502 ER25 Manual De Instrucciones página 18

All of the assembled tools displayed are shown in basic setting 0.
When fitting the tool, the indexable insert must point in the direction of the positive adjustment direc-
tion (+) of the slider.
DE DE
With the use of boring bars 4 and 5 as well as the cartridge holder 2, screw in grub screw D
= central coolant transfer.
Screw back screw C until the location bore is free. Insert the boring bar with the clamping surface
towards the screw. Clamp boring bar 4 or 5 using screw C to 5 Nm.
Loosen screw A.
Place tool on pre-setting device: adjust finely using graduated dial. Here, one turn of the graduated dial
corresponds to an ⌀-adjustment of 1 mm.
Using the scale, adjustments of 0.01 mm can be made from graduation to graduation or of 2 μm using
the vernier.
Clamp slider B to 6 Nm with screw A.
EN
FR FR
IT IT
ES ES
18