Publicidad
Idiomas disponibles
Idiomas disponibles
All of the assembled tools are shown in basic setting 0.
When fitting the tool, the indexable insert must point in the direction of the positive adjustment direc-
tion (+) of the slider.
DE
DE
From a diameter of 63 filler piece 3 must be fitted for coolant redirection and grub screw D unscrewed
until the circlip stop.
The minimum coolant pressure of 5 bar must be maintained.
The increasing of the coolant pressure to 10–20 bar improves the machining process and should there-
fore be aimed for.
Screw back screw C until the location bore is free.
Insert filling piece 3 with the clamping surface towards the screw.
Clamp filling piece 3 using screw C to 5 Nm.
Fit cartridge H2 or H3 , adjust using graduated scale and fasten to 5 Nm using cheese-head screw 6
(spring disc/plain washer).
EN
Loosen screw A.
Place tool on pre-setting device: adjust finely using graduated dial.
One turn of the graduated dial corresponds to a ⌀ adjustment of 1 mm.
Using the scale, adjustments of 0.01 mm can be made from graduation to graduation or of 2 μm using
the vernier.
Clamp slider B to 6 Nm with screw A.
FR
FR
IT
IT
ES
ES
20
Publicidad
