Installing The Hob; Selecting The Installation Location - Dometic EK 1600 Instrucciones De Montaje

EK1600, EK3200
7

Installing the hob

The hob can be installed in your kitchen worktop.
7.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
•
Select a well-ventilated location for the device.
Ensure the following minimum clearances (fig. 2, page 3):
•
– 150 mm to the side walls
– 170 mm to the back wall
– 500 mm between the burner and horizontal surface above the hob
– 10 mm between the bottom of the hob and the surface base.
•
Ensure that there are no draughts in the installation location.
If the hob is installed in an open cockpit or other exposed location, then also
install an additional wind guard.
•
Do not operate the device in rooms that are potentially explosive.
•
If gimbals (accessories) are used, ensure that the stove can swing freely.
•
Ensure you have ample room to swing the gimballed range (accessories).
7.2 Installing the hob
A
NOTICE! Risk of damage!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
If you don't use gimbals, mount the stove as follows:
➤ Fasten the hob in place using four screws.
EN
Installing the hob
11