Assembly; Operation - Ryobi P3340 Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General ventilation of most household spaces

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
INSTALLING THE FAN HEAD ONTO THE
FRAME
See Figure 1, page 8.
NOTE: Do not operate the fan or connect the power cord
or battery pack without first installing the fan head onto the
frame.
 Align the upper tubes on the fan head with the lower tubes
on the frame as shown. The spring-loaded locking pins
should be aligned with the holes in the lower tube.
 Push the fan head and frame together until the locking
pins click into place in the holes.

OPERATION

WARNING:
Hybrid tools are always in operating condition. Therefore,
switch should always be in the OFF ( 0 ) position when
not in use.
NOTICE:
This product is designed to be powered by either a
RYOBI
™
electric power (AC mode). Either power source can be
used by installing an approved battery pack or power
cord into the product as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.
 Place the speed switch in the OFF ( 0 ) position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
6 – English
ONE+ 18V battery pack (DC mode) or by
™