Ryobi RYEDG11 Manual Del Operador página 9

JOINING THE EDGER ATTACHMENT TO THE
ATTACHMENT SHAFT
See Figure 2.
This product requires a one one-time assembly of the edger
head to the attachment shaft.
 Remove rubber end cap from edger attachment shaft
before installing.
 Install the edger attachment shaft into opening on the
gear head so that the hole on the top of the attachment
shaft lines up with the shaft screw. Be sure the arrows
on the gear head and the edger attachment shaft meet.
 Tighten the shaft screw into the hole on the edger
attachment shaft.
NOTE: When the screw is properly installed the screw
head will be completely seated against the casting. If this
is not the case, the screw is not installed properly.
 Tighten securely by turning the gear head screw to clamp
gear head around shaft.
NOTE: When fully secure, the shaft cannot be rotated.
JOINING THE POWER HEAD TO THE EDGER
ATTACHMENT
See Figure 3.
WARNING:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine or motor could cause
serious personal injury.
The edger attachment connects to the power head by means
of a coupler device.
ASSEMBLY
 Remove the spark plug wire or disconnect from the power
supply.
 Remove the hanger cap from the attachment.
 Loosen the knob on the coupler of the power head shaft.
 Push in the button located on the edger attachment. Align
the button with the guide recess on the power head cou-
pler and slide the two shafts together. Rotate attachment
shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
rotate from side to side until the button is locked into
place.
 Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
 Stop the engine or motor and remove the spark plug wire
or disconnect from the power supply.
 Stop the engine or motor.
 Loosen the knob.
 Push in the button and twist the shafts to remove and
separate ends.
7 — English