First Time Start-Up; Operational Instructions - SILANOS N1300 DOBLE Manual De Istrucciones

The electrical protection system must be put through a functional test before starting up the appliance. It must be installed
and/or checked by the authorized retailer who will start it up for the first time and provide instructions on how the dishwasher
works.
PREPARING FOR USE
The rinse aid dispenser is always installed, but the detergent dispenser only on some models.
If both dispensers are installed, put the external detergent and rinse aid containers in place and insert the priming pipes
(situated at the back of the machine) into them accordingly.
Red pipe: detergent / clear pipe: rinse aid.
Before inserting the pipes into the containers, fit the weight at the ends so that they stay at the bottom of the container and also
the filter, as indicated in fig. 2. To adjust, turn the adjustment screws, as shown in fig. 1-3; you are recommended to have the
adjustment done by personnel of the detergent suppliers.
If the detergent dispenser is not pre-fitted, it can be installed later by ordering the related KIT (contact the technical service).
Dishwashers without detergent dispenser: put the detergent directly into the tank every 4-5 cycles approximately; for the type
and quantity to use, follow the instructions given by the detergent supplier.
Use exclusively detergents and rinse aids for industrial dishwashers. Do not use normal detergents for dishwashing by hand.
You are recommended to use exclusively products that have been studied specifically for this dishwasher.
Make sure not to mix up the detergent and rinse aid containers when topping them up, as the wrong product in the
wrong container could cause malfunctioning and could damage the dishwasher.
Do not mix different detergents, as this could damage the dispensing device. Detergents for industrial dishwashers can
cause serious irritations. Follow the instructions of the detergent supplier written on the package.
Open the
the level of
mains water
detergent and rinse
cock (utility).
aid in the
containers.
5 – FIRST TIME START-UP
6 – OPERATIONAL INSTRUCTIONS
Check:
that the filters are in the correct position, the spray arms
turn and that there are no foreign bodies in the
dishwasher.
MACHINE SWITCHED OFF : SCREEN OFF
When the machine is OFF, it shows "OFF", the date and time and possibly the icon in the
bottom left part, if the automatic switch-off timer is enabled (see page 8). Just the ON/OFF
button is lit. From OFF status, you can switch the machine on by pressing the ON/OFF
button for 2 seconds.
You can access the user menu and the technician's menu (after entering a password) by
pressing the M button for 3 seconds.
SWITCHING THE MACHINE ON
After inserting the filters and the overflow (if provided), press the ON/OFF button for 2
.
seconds
Only for models N1300, insert one empty basket in order to activate the
switch.
The dishwasher will switch on.
The initial logo will appear and an indication of the osmosis system (if installed and if
enabled in the user menu). Then the normal operating screen will appear.
If the tank or the boiler is empty, the machine will start to fill.
If there is a built-in osmosis system, its activation will be pointed out during the filling phase.
The automatic timer icon will appear (if enabled in the user menu).
The tank will continue to fill until the correct level is reached.
Switch the main
ON/OFF switch on
(utility)
20