SILANOS N1300 DOBLE Manual De Istrucciones página 25

8 – USER MENU AND PARAMETERS
From the OFF screen page, press button M (off) for 3 seconds to access the menus.
Once you have selected the required item, press the START button to be able to modify
the parameters:
Use the + (forward), - (back) buttons and press the START button again to confirm.
Press the M button to exit the SETUP page.
User setting menu: you can also access this in Stand-by mode
Clock: adjust the time in hours and minutes
Brightness: increase/decrease the brightness of the display
Buzzer: acoustic indicator
Language: choose the language
Enable/Disable the osmotic function
With the "Timers Enabl." Parameter you can enable or disable the automatic switch-off
function.
You can set a switch-off time for each day. If the switch-off time is after midnight, an
asterisk will appear next to the time.
Daily cycles: wash cycles performed during the day; it resets at midnight (24.00)
Tot. Wash cycles: total wash cycles performed
This page shows the software releases installed on the boards.
Basic FW: software release on the Basic board
LCD FW: software release on the LCD board
The revisions illustrated are just an example.
9 – ERRORS DISPLAYED/PROBLEMS
Boiler/tank not filled within the set time.
SOLUTIONS:
- Make sure the overflow is fitted properly in place (if there is
one).
- Check the mains water inlet.
- Press the START button (red) to reset the count.
- If the problem persists after switching off and on again, call
the technical assistance service and inform them of the type
of error on the display.
25