SILANOS N1300 DOBLE Manual De Istrucciones página 21

HEATING PHASE
Once full, the rinse and washing water will be heated.
The icon of the tank and of the boiler will be yellow; this means they are in the heating
phase.
Once the set temperatures have been reached, the icons will turn green.
This means the machine is ready to start a washing cycle.
LOADING THE DISHWASHER
Remove any solid leftovers from the plates (bones, peel, nuts etc); leave the plates to soak
in cold water if there are any stubborn leftovers, such as dried cheese, egg etc.
Put the glasses in the basket with their stem upwards.
Use the cutlery basket for cutlery. Put the cutlery loose in the basket, preferably with the
handle at the bottom. Be careful not to injure yourself on the fork prongs and knife blades.
CHOOSING AND STARTING A WASH PROGRAM
You can select the wash program using the + and - buttons.
The wash programs are the following:
P1: duration 80" – wash temperature 55° - rinse temperature 70°
P2: duration 120" – wash temperature 55° - rinse temperature 75°
P3: duration 180" – wash temperature 55° - rinse temperature 80°
P4: duration 480" – wash temperature 60° - rinse temperature 80°
OPTIONAL:
P5: program for beer glasses (cold rinse) duration 130" – the cold rinse temperature is
established by the mains system.
Once you have selected the required program, you can press START or close the hood to
start the wash cycle.
The START button will turn blue and the display will show the countdown to the end of the
complete wash cycle. Wash cycle in progress screen page.
If the door/hood is opened while the washing cycle is in progress, it will stop to start again
when the door/hood is closed again, if this is done within 20 seconds, otherwise, after 20
seconds, the cycle will reset. Program P4 can be used to finish with the rinse cycle, by
pressing the START button again (blue) during the wash phase.
EXTENDING THE WASH PHASE: THERMOSTOP (CAN BE ACTIVATED FROM THE
TECHNICIAN'S MENU)
If the wash time ends and the rinse phase has still not reached the set temperature, the
wash cycle is extended until the set rinse temperature is reached.
Display of the thermostop function enabled.
WASH PROGRAM WITH CRV (IF INSTALLED):
The wash program ends with a steam extraction and recovery phase.
The countdown indicates the remaining time to the end of this phase. You are
recommended NOT to open the door during the recovery time, as this will help to save
electricity.
Last phase: 30 seconds activation of the fan with scrolling written indication.
21