Adjustable Head - RIDGID R8694221 Manual Del Operador

Panel de luz híbrido replegable de 18 v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
INSTALLING/REMOVING POWER CORD
See Figure 2, page 10.
WARNING:
Do not route cord under carpets, rugs, runners,
furniture, or appliances and always route cord
away from traffic areas to prevent a tripping hazard.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source. Make sure the power cord is seated securely
before beginning operation.
 To remove the power cord, disconnect the cord from the
power source and then from the rear of the light.
OPERATING THE PANEL LIGHT
See Figures 3 - 4, pages 10 - 11.
WARNING:
Hybrid tools are always in operating condition.
Therefore, unit should always be in the OFF sta-
tus, with the battery pack removed and power
cord disconnected, when not in use. Do not leave
light on while unattended. Failure to follow these
instructions could result in serious personal injury.
 Install battery pack or connect product to an AC power
supply.
 Press the on/off/brightness knob to turn panel light on
and off.
 Rotate the on/off/brightness knob to choose the desired
light intensity. Rotating counterclockwise will give less
light; rotating clockwise will give more light.
 Place the light's adjustable panels in the positions
needed to direct light as desired.
WARNING:
Keep panel light away from combustible materials.
If wrapped or in contact with fabrics, the panel
light lens can produce sufficient heat to melt some
fabrics. To avoid serious personal injury, never
allow the panel light lens to come in contact with
anything.

ADJUSTABLE HEAD

See Figure 5, page 11.
CAUTION:
Do not place hands or fingers between adjustable
head and frame when positioning panel light to
avoid pinching your fingers or hands.
In addition to adjusting the individual LED panels of the
light, the adjustable head can also be set in a variety of
positions. To adjust positions:
 Loosen the head adjustment knob.
 Adjust head to desired position.
 Tighten knob to secure.
MOUNTING/HANGING THE PANEL LIGHT
See Figures 6 - 10, page 11.
In addition to sitting upright on its base on a flat surface, the
panel light offers a variety of hanging and mounting options in
both the vertical and horizontal position to suit your specific
location and needs.
NOTE: Be careful not to position the panel light in such a
way that prevents normal operation or damages the cord.
WARNING:
Only hang or mount the panel light in an area where
no electrical wires, utility cables, pipes, or other
obstructions are located. Contact your local utility
company or a qualified electrician if you are unsure.
Do not hang panel light from any electrical power
cord. Ensure panel light is securely installed to
prevent falling object hazard. Failure to follow these
instructions can result in electrocution, electrical
shock, or other serious personal injury.
Hanging the panel light using the keyholes:
 Install two screws approximately 2-7/8 in. apart.
 Place the wide portion of the keyholes over the heads of
screws.
 Slide the panel light down until the screws are inside
the narrow portion of the keyholes and the panel light is
secure.
7 – English

Publicidad

Tabla de contenido
loading

Tabla de contenido