Quick Tips - Fell Marine MOB+ Manual De Usuario

Press and Hold to Pair
Pair any MOB+ xFOB to any MOB+ xHUB. Your xHUB remembers the last
20 paired xFOBs. Only one xFOB can be actively connected to the xHUB
when in operation, but up to 20 xFOB's can be paired and reside in the
memory of the same xHUB. This enables multiple drivers of the same
boat to have their own xFOB unit. If one xFOB unit is connected and
another attempts to connect a paired unit, this will not affect the system
as it only communicates with the unique ID of the connected unit.
One click – Connect / Disconnect System
After your xFOB and xHUB are paired for the first time, click your xFOB
once when entering the boat to start driving. You are now free to move
around safely. When disembarking the boat – click the xFOB once more
to disconnect.
MOB situation and Direct Restart System
WiMEA Protocol automatically triggers MOB Mode (Man Overboard
®
Mode) when the xFOB goes into the water or travels out of range from
the connected xHUB. 6 seconds after stopping the engine the Override
Mode is engaged and
automatically switches the signal relay to the engine back on. This allows
any passengers on board to quickly restart the engine and pick up the
missing driver in the water, without the need to interact with the xHUB.
Installation tips
• Find installation instructions for your engine on www.fellmarine.com/
support
• Use a standard 2-1/16" (52mm) hole saw for the xHUB mounting
• Use the included heat shrinkable splices to ensure all wiring
connections are waterproof.
• For multiple engines use the engine manufacturers provided
solution, this may vary across different engine brands.
See www.fellmarine.com/support
brand.
5

Quick tips

for information about your engine