Maintenance
To reinstall the door
52 English
NY9900R_CHEF_NY36R9966PS_AA_DG68-01105B-00_EN+MES+CFR.indb 52
1.
Firmly grasp both sides of the door at
the top.
2.
With the door set at the same angle as
the removal position (about 5 degrees
from vertical), slide the hinge arms into
the hinge slots at the bottom of the
door.
3.
Open the door fully. If you cannot open
the door fully, the hinge arms are not
set properly in the hinge slots.
4.
Lock the hinge arms by pushing them
up against the front frame of the oven.
5.
Close the door, and make sure it opens
and closes normally.
Replacing the oven lights
Oven lights (2 Locations)
There are 2 oven lights, one on each side oven wall. To replace a light, follow these
steps:
1.
2.
3.
CAUTION
To prevent electric shock, make sure the Electric oven is turned off and cool before
replacing the oven light.
NOTE
•
The oven lights do not operate during a self-cleaning cycle.
•
Remove the racks if they prevent you from accessing an oven light.
Hold the lower end of the side oven
light cover with one hand, and then use
a flat-sharp tool such as a table knife to
remove the cover as shown.
Replace the side oven light.
Reinsert the light cover.
2019-02-06
1:26:39