Changes To Settings; Doctor's Function; Cleaning And Storage; Disposal - Beurer EM 41 Manual De Instrucciones Para El Uso

i Note: Your individualised programme settings are stored and automati-
cally retrieved when you select it next.
7.4 Changes to the settings
Changing intensity (during application)
• CH1+/- and CH2+/-: Changing the intensity for each channel.
• DOWN key : the intensity of both channels is reduced.
Interrupting stimulation
Press the ON/OFF button.
If you press it again, the application is resumed.
Switching off a complete channel
Press the CH- key until the channel reaches the lowest intensity, then hold
the key depressed until the channel no longer appears in the display.
Hold down the corresponding key CH+ to reactivate the channel.
Changing application (completely or single parameters)
• ON/OFF: to interrupt stimulation
• MENU: back to program selection window or main menu
• Set required parameters. Confirm with ENTER. Press ON/OFF to continue
application.

7.5 Doctor's Function

Doctor's Function is a specific setting to allow you to call up your specific
personal programme even more easily.
Your individual programme setting is immediately retrieved in wait status
when you switch on and is activated by simply pressing the ON/OFF key.
Settings for this individual programme may, for example, be on the advice of
your doctor.
With the Doctor's Function, only pulse intensity can be changed during
stimulation treatment. All other parameters and programmes of the Digital
TENS/EMS are blocked in this case and cannot be modified or called up.
Setting the Doctor's Function:
• Select your programme and appropriate settings as described under 7.2
or 7.3.
• Before you activate the programme by pressing the ON/OFF key, hold ON/
OFF and CH 2+ keys down simultaneously for approximately 5 seconds.
Storage in Doctor's Function is confirmed by a long signal tone.
Cancelling Doctor's Function:
To clear the device again and access other programmes, hold down the two
keys ON/OFF and CH 2+ once again for approximately 5 seconds (not pos-
sible during stimulation). Cancelling of the Doctor's Function is confirmed by
a long signal tone.

8. Cleaning and storage

Adhesive electrodes:
• In order to ensure that the electrodes adhere for as long as possible, they
should be cleaned carefully with a damp, lint-free cloth.
• After use, stick the electrodes onto the backing film.
Cleaning the unit:
• Remove the batteries from the device every time you clean.
• Clean the unit after use with a soft, slightly moistened cloth. In case of
more extreme soiling you can also moisten the cloth with mild soapy
water.
• Ensure that no water penetrates into the machine. If this should ever hap-
pen, only use the machine again once it is completely dry.
• Do not use any chemical cleaners or abrasive agents for cleaning.
Storage:
• Remove the batteries from the unit if you are not going to use it for a
longer period. Leaking batteries can damage the unit.
• Do not make any sharp kinks in the connecting leads or electrodes.
• Detach the connecting cable from the electrodes.
• After use, stick the electrodes onto the backing film.
• Store the machine in a cool, well-ventilated place.
• Never place any heavy objects on the machine.

9. Disposal

Used, fully discharged batteries must be disposed of in a specially labeled
collection container, at toxic waste collection points or through an electrical
retailer. You are under legal obligation to dispose of batteries correctly.
Note: You will find these markings on batteries containing harmful
substances: Pb = battery containing lead, Cd = battery containing
cadmium, Hg = battery containing mercury.
27