To Use - Beurer FC 100 Instrucciones De Uso

5. To Use

CAUTION
• Do not use the device more than once a week.
• Immediately after use, treated skin may be slightly reddened and, in very rare cases, have small
spots of bleeding under the skin.
• For one day before and one day after use, avoid activities that cause you to perspire, such as
saunas, tanning beds and sun exposure.
NOTES
• Before use, make sure that your face is clean, dry, and free of powders, creams, or makeup.
• Apply only slight pressure during use. Usage should not be painful, although some slight skin
reddening can occur after use.
Skin Test:
Perform a skin test 24 hours before using the device. Gently test the device at its lowest intensity on small,
inconspicuous areas of your neck. If, after 24 hours, the tested area is red or painful, do not use the device.
1. Connect the power cord to the device and plug the adapter into an
electrical outlet.
2. Press the Lid Release.
3. Remove a Single-use Filter from its storage case and insert it into the
end of the Vacuum Tube.
4. Press the Handle onto the Vacuum Tube.
5. Press the desired Head onto the end of the Handle.
6. Press the ON/OFF Button to switch on the device. The Intensity Level
Display will illuminate and indicate the selected intensity level, which
upon first use will be Level 1.
7. Start treatment at the lowest intensity level. Place the head against
your face, with the Handle perpendicular to your skin, and slide it gently
around. Make sure that you do not cover any area more than once. Details
on treatment can be found in the "Application Areas" section below.
8. To change the intensity level, press the -/+ Buttons.
9. When you are finished using the device, press the ON/OFF Button to
shut it off and unplug the AC Power Adapter from the outlet.
10. Change the Single-use Filter after every use. To do so, detach the Han-
dle from the Vacuum Tube and remove the filter, using a pair of tweezers
if necessary.
4
2
3
4
5
6
10