Making Changes With Sound Adjustment Mode - Eclipse CD4000 Manual Del Proprietário

Making changes with Sound Adjustment Mode

1
Press the [SOUND] button more than one second.
Enters sound adjustment mode.
2
Turn the [SEL] button to select a setting item.
When the button is turned, the setting item changes in the following order.
Press the [SEL] button to select the setting item. After selecting the setting item, follow
the procedures in the list below.
Crossover adjustment (X-Over F/R)
Adjusts woofer (non-fader output) LPF (Low Pass filter). The system allows you to select from several cut off
frequencies: PASS, 80Hz and 100Hz.
1
Turn the [SEL] button to select the cut-off frequency.
2
Press the [SEL] button.
ATTENTION: Slope is fixed at 18dB/oct. Adjustments cannot be made.
Crossover adjustment (X-Over NF)
Adjusts woofer (non-fader output) LPF (Low Pass filter). The system allows you to select from several cut off
frequencies: PASS, 80Hz and 100Hz.
1
Turn the [SEL] button to select the cut-off frequency.
2
Press the [SEL] button.
ATTENTION: Slope is fixed at 18dB/oct. Adjustments cannot be made.
Non-Fader phase selection (Non-F Phase)
The merging of sound between the front and rear speakers and the woofer can be improved by selecting the
phase. Switch to a phase which lets the speakers combine without any disharmony.
1
Turn the [SEL] button to select the NORMAL or REVERSE.
2
Press the [SEL] button.
3
Press the [RTN] button.
At this time, other adjustments can also be made in sound adjustment mode.
4
Press the [SOUND] or [RTN] button to exit sound adjustment mode.
How to operate the Sound Adjustment Mode
PASS ➔ 80 (Hz) ➔ 100 (Hz) ➔ PASS
...
PASS ➔ 80 (Hz) ➔ 100 (Hz) ➔ PASS
...
NORMAL: Normal phase
REVERSE: Reverse phase
X
41