Installation Instructions; Safety Warnings - STEINEL IS 2160 Instrucciones De Montaje

Installation instructions


Dear Customer,
Congratulations on pur-
chasing this STEINEL Inf-
rared Sensor and thank
you for the confidence
you have shown in us.
You have chosen a high-
quality product that has
Principle
The integrated pyroelec-
tric infrared detector
senses the invisible heat
radiated from moving
objects (people, animals,
etc.). The heat detected is
electronically converted
into a signal that switches
on loads (e.g. a light) con-
nected to it. Heat is not
detected through obsta-
cles, such as walls or
panes of glass. Heat ra-
diation of this type will,
therefore, not trigger the
sensor.

Safety warnings

Disconnect the power

before attempting any
work on the motion
detector.
The electrical connec-

tion lead must be dead
during installation.
Therefore, switch off
the power first and
use a voltage tester to
check that the power
supply is disconnected.
12
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
been manufactured,
tested and packed with
the greatest care.
Please familiarise yourself
with these instructions
before attempting to in-
stall the sensor since
prolonged reliable and
With a detection angle of
160° and a max. reach of
12 m the sensor watches
over an area of approx.
165 m . If you only wish
2
to cover a smaller area,
reach may be reduced
by tilting the sensor unit.
Using the swivel mount
supplied, the sensor
unit can also be turned
horizontally, making it
possible to target the
detection zone exactly
as you choose. The
detection angle can also
Installation of the

sensor involves work
on the mains power
supply. This work must
therefore be carried
out professionally in
accordance with the
applicable wiring regu-
lations and electrical
operating conditions.
( - VDE 0100,
D
- ÖVE-EN 1,
A
- SEV 1000).

trouble-free operation will
only be ensured if it is
installed properly.
We hope your new Infra-
red Sensor will give you
lasting satisfaction.
(s. fig. page 2)
be adjusted to suit individual
requirements by fitting
shrouds.
Important: the safest mo-
tion detection is obtained
when the device is moun-
ted and aligned laterally to
the walking direction and
no obstacles (such as
trees and walls, for ex-
ample) obstruct the view.
Please note that the

sensor must be pro-
tected by a 10 A circuit
breaker. The mains
supply lead must be
no greater than 10 mm
in diam-eter.