Hitachi NT 65GS Instrucciones Y Manual De Seguridad página 25

(3) Push the nail feeder (A) to engage the nail
feeder (B) to the nail strip.
Nail feeder (B)
NOTE:
Quietly push the nail feeder (A) and nail
feeder (B) against the nail.
If the nail feeder (A) and nail feeder (B)
are released from backward the
magazine and bumped against the nail,
the connecting adhesive of the nail can
be damaged.
Use nail strip of more than 10 nails.
Use an unbroken nail strip with nails of
all the same length.
The Nailer is now ready to operate.
Removing the nails:
1 Pull the nail feeder (B) backward.
2 Return the nail feeder (B) forward quietly
while pushing the nail feeder (A).
3 Pull out nails from the back of the
magazine.
1
2
Nail feeder (B)
Nail feeder (A)
Nail feeder (A)
Nails
<NT50GS>
(1) Lightly press the stop lever and gently
pull out the magazine cover.
Magazine cover
(2) Set nail strip into the magazine and keep
the points of nails in contact with Groove.
Nail strip
Magazine
NOTE:
The nails shown in page 17 can be loaded
onto the side guide groove of the
magazine without any adjustment.
Always keep the points of nails in contact
with Groove.
English
3
Press
Pull out
Stop lever
Groove
25