Troubleshooting - JVC KD-X252 Manual De Instrucciones

REFERENCES
Change the display information
Each time you press , the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO NAME", or
other information (eg. station name) appears or display will be blank.
Source name Display information
FM or AM Frequency Clock
(For FM Radio Data System stations only)
Station name (PS)/Program type (PTY)
text+ Radio text+ title/Radio text+ artist
Clock (back to the beginning)
USB (For MP3/WMA/WAV/FLAC files)
Song title/Artist Album name/Artist
File name Playing time
beginning)
iPod or When [HEAD MODE]/[AUTO MODE] is selected ( 6):
ANDROID Song title/Artist Album name/Artist
Clock (back to the beginning)
AUX AUX Clock (back to the beginning)
(back to the beginning)
Radio text Radio
Frequency
Folder name
Clock (back to the
Playing time

TROUBLESHOOTING

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
• Radio reception is poor.
• Static noise while listening
to the radio.
Playback order is not as
intended.
Elapsed playing time is not
correct.
"NOT SUPPORT" appears and
file skips.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the USB device.
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with this unit and
or connected device cannot
be detected. • Reattach the device.
The iPod/iPhone does not • Check the connection between this unit and iPod/iPhone.
turn on or does not work • Disconnect and reset the iPod/iPhone using hard reset.
Correct characters are not • This unit can only display uppercase letters, numbers, and a limited
displayed.
• Depending on the display language you have selected ( 4),
Remedy
Turn the power off, then check to be sure the terminals of the
speaker wires are insulated properly. Turn the power on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. ( 4)
Connect the antenna firmly.
The playback order is determined by the file name .
This depends on the recording process earlier.
Check whether the file is a playable format. ( 12)
ensure the files are in supported formats. ( 12)
number of symbols.
some characters may not be displayed correctly.
13
ENGLISH