Sanding Motion; Choice And Installation Of Sanding Pads - Rotex RO 125 FEQ Manual De Instrucciones

7 .1
7 .2
6 .1
You can use the switch (6.1) to set two different
sanding motions.
the sanding pad is stationary, as the switch is
locked in place during operation for safety rea-
sons.
Rotex rotary motion (coarse sanding, polishing)
The Rotex rotary motion is a combination
of rotary and eccentric motions. This mo-
tion is recommended for sanding with ag-
gressive material removal (coarse sand-
ing) and polishing.
Slide the switch (6.1) into the right position.
Eccentric motion (fi ne sanding)
This motion is recommended for sanding
with low material removal for a scratch-
free fi nish (fi ne sanding).
Press the switch (6.1) down and push it into the
left-hand position.

Choice and installation of sanding pads

Choice of sanding pad
The tool can be fi tted with three sanding pads of
different hardnesses depending on the surface
to be sanded.
Hard: Coarse sanding on surfaces, sanding at
edges.
Soft: Universal use for coarse and fi ne sanding
for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts, curves,
radii. Do not use on edges!
Installation
The FastFix system enables tool-free replacement
of the sanding pad:
– Set the switch (7.1) to the right for the Rotex
rotary motion,
– Press spindle stop (7.3), direction of movement
fi rst to the side, then forwards,
– Turn the fitted sanding disk (7.2) from the
spindle (right-handed thread),
7 .3
– Keep the spindle stop pressed and screw on
the new sanding pad (in doing so, make sure
that the rubber collar (10.1) is correctly fi tted!),
– Let go of the spindle stop.
8

Sanding motion

The change can only be made when