Technical Data - Beper 40.991A Manual De Instrucciones

Nail Gel UV Lamp Use instructions
Get the four bulbs ready to insert. Fig. 3
• Take the first one and plug it carefully into the socket with slight pressure until latched.
• Repeat the handling with the remaining bulbs.
• Remove the protective film from the base plate and slide it back in place.
• Connect the plug; make sure that the cable is flat on the ground.
• If needed use an extension.
• After the nail curing, place switch into the off position and unplug the connector.
USE
O = switch off
II = timer
I = switch on
Red button: switch 120 second timer on.
CLEANING
• Clean only with a smooth dry cloth.
• Do not use any dissolver or detergent.
• Store in a dry and safe place. Keep out of reach of children.

TECHNICAL DATA

Power 220V–240V~50/60Hz
Max. capacity :36W
UV bulbs: 9W, 365 nm
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa-
tely collected.
9