Purpose Of Use; Work Area Safety - Beta 1951A Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR CLEANING GUN WITH EXTRACTOR MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY
STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

- The pneumatic cleaning gun can be used for the following purposes:
• cleaning car interiors with environmentally-friendly detergents
• cleaning car upholstery, carpeting, seats, interiors and boots
- The reversible air ratchet must not be used for the following operations:
• the pneumatic cleaning gun must not be used with petrol, oil and by-products
• the pneumatic cleaning gun must not be used with paints or acids
• the trigger must not be locked with adhesive tape or clamps
• the pneumatic cleaning gun must not be used for any applications other than stated ones

WORK AREA SAFETY

Keep children and bystanders away from your workplace while operating the pneumatic tool. Other people cause
distractions.
Beware of both the danger of tripping over the air hose and the surfaces that may become slippery due to the use of
detergents during cleaning jobs.
PNEUMATIC TOOL SAFETY
- Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications in
terms of pressure and air volume. Too low pressure impairs the function of the pneumatic tool; too high pressure can cause
damage and/or injury.
- Do not bend or tighten any hoses. Avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating
parts. Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed
air pipe. Raised dust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
- Never carry the pneumatic tool by the hose.
PERSONNEL SAFETY
- Stay alert; watch what you are doing. Do not use the pneumatic tool while tired or under the influence of drugs, alcohol,
or medication.
- Always use the following personal protective equipment:
• eye protection;
• protective mask;
• protective gloves against chemical agents;
- Do not direct the flow of the atomized solution towards yourself, other people or animals. Avoid contact with eyes.
- The air used in the pneumatic tool may contain water, oil, metal particles and impurities, which may cause hazards.
PNEUMATIC TOOL USE AND CARE
- Do not overload the pneumatic tool: only use it for the intended work.
- Always check that the pneumatic tool is free from defects. Do not use it if the start/stop lever is defective. A tool that can no
longer be stopped or started is dangerous and must be repaired.
- Always disconnect the air supply before carrying out any jobs on the pneumatic tool. This safety measure prevents accidental
starting of the tool.
EN I
5