Beta 1951A Manual De Uso E Instrucciones página 7

EN I
OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
INSTRUCTIONS
Air supply connection
For correct use of the pneumatic tool, always keep to a maximum pressure of 6.2 bars, as measured at the tool inlet. Feed the
tool with clean, condensate-free air. Excessively high pressure or humidity in supply air may damage the tool.
USE
Start / Stop
Fully loosen the tank; unscrew it until it is removed. Pour in the detergent. Dilute the product according to its characteristics, if
need be. Install the tank by screwing it in. To start the gun, press the start lever. Keep it pressed during the job to be performed.
Releasing the lever will cause the gun to stop quickly. The tool is fitted with a detergent dispensing tap.
Extraction
During cleaning jobs, the product can be directly extracted by connecting a fluid extractor to the gun. Use the hose to connect
the gun to the extractor (drain on upper part of gun). Start the extractor and proceed with cleaning, making sure that the gun front
is in contact with the surface that is being cleaned, to allow for proper extraction of the product.
When cleaning is complete, turn off both the gun and the extractor. It is recommended that the liquid not be released into the
environment and be disposed of in accordance with current provisions.
Compatible with Beta extractor item 1873-1874
Always disconnect the air supply before any insertions or before adding detergent. This precaution will prevent the gun
from being accidentally started.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.'s
repair centre through your Beta dealer.
DISPOSAL
The gun, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for
professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at
our discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain
unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty
will no longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
7