Safety Instructions - Perel Tools AHJ10T Manual Del Usuario

Gato hidráulico para reparar carrocerías
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

AHJ10T – 10-TON HYDRAULIC BODY REPAIR KIT
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the AHJ10T! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• This equipment should be operated by professional personnel only.
• Keep hands and body clear of all pinch points.
• This equipment is designed for use only with body/frame equipment and attachments. Use with any other
equipment may result in overloading, reduced load capacity, reduced stability and/or system failure.
• Do not overload. Overloading is often indicated by bowing extension tubes or slipping attachments and can result
in personnel injury and/or damage to the equipment.
• Maintain proper oil level. Overfilling may cause damage to or failure of this equipment.
• When offset attachments are used, the rated capacity is always reduced by 50%. For each additional extension
tube used in the setup, the overall capacity is reduced by 50%. Refer to "Load Capacities" at the back of the
manual for typical setups and corresponding load capacities.
• Do not connect the pump to any ram that is fully or partially extended.
• Prior to applying a load, please ensure that all attachments and extension tubes are fully engaged.
• Ensure that the load is centrally applied to the attachments and ram saddle to minimize an off-centre load
condition.
• Use a force gauge to verify the actual load being applied for various types of setups.
• Frequently inspect this repair kit carefully for any damages or missing parts.
• Keep the work area clean. Keep the device away from children and unauthorized users.
3. Attachments
1. extension tubes (10, 20, 30, 45cm)
2. hydraulic spreader
3. ram toe
4. plunger toe
5. wedge head
6. serrated saddle
7. 90° comb head
8. rubber head
AHJ10T
3
PEREL

Publicidad

Tabla de contenido
loading

Tabla de contenido