Assembly And Operation; Cleaning And Maintenance; Technical Specifications - Perel Tools AHJ10T Manual Del Usuario

4. Assembly and Operation

1. release valve
2. hose
3. hose coupler
4. ram coupler
5. attachment
6. ram plunger
7. thread protector
8. ram
9. air vent valve
• To prepare the pump and the ram for operation, remove the dust cover from both the hose coupler (3) and the
ram coupler (4). Connect the hose (2) to the ram (8). Select the appropriate attachment (5) and assemble onto
the plunger (6).
• When using the extension tubes, never mount the shortest tube in the middle but mount them at the end.
• Close the release valve (1) by turning it clockwise until snug. Never over-tighten. Operate the handle so as to
extend the plunger and continue pumping until the desired operation is complete.
NOTE: Before operating the unit, loosen the air vent valve (9) by turning it in an anticlockwise direction. This may
improve pumping efficiency. When the unit is not in use, close the air vent valve to avoid oil leakage. Do
not close the air vent valve unless the ram is fully retracted.

5. Cleaning and Maintenance

• Store your AHJ10T in a dry place with the release valve opened.
• After prolonged use, change the oil inside the pump. Open the pump system and the release valve, and empty all
oil. Close the release valve, refill with oil (± 500g) and close the pump system. Please use appropriate oil.

6. Technical Specifications

Load Capacity
Velleman cannot be held responsible in the event of damage or injury resulted from (incorrect) use of this
device.
For more info concerning this product, please visit our website www.perel.be.
The information in this manual is subject to change without prior notice.
AHJ10T – VÉRIN HYDRAULIQUE À DÉBOSSELER – 10 TONNES
1. Introduction
Aux résidents de l'Union européenne
Des informations environnementales importantes concernant ce produit
Ce symbole sur l'appareil ou l'emballage indique que l'élimination d'un appareil en fin de vie peut polluer
l'environnement.
Ne pas jeter un appareil électrique ou électronique (et des piles éventuelles) parmi les déchets municipaux
non sujets au tri sélectif ; une déchèterie traitera l'appareil en question.
Renvoyer les équipements usagés à votre fournisseur ou à un service de recyclage local.
Il convient de respecter la réglementation locale relative à la protection de l'environnement.
En cas de questions, contacter les autorités locales pour élimination.
AHJ10T
10t
4 PEREL