Assembly - Protemp PT-16-TTC Manual Del Usuario E Instrucciones De Operación

Model PT-32-TTC:
Tools Needed:
– Medium Phillips head screwdriver.
1. Place the tank collar bracket on top of the
center plate. Be sure the mounting bolt knob is
on bottom as shown in Figure 1.
2. Insert machine screw into top hole using
Phillips head screwdriver.
3. Insert 2nd machine screw into bottom hole.
This will secure the tank collar bracket to the
center plate.
WARNING DO NOT adjust burner heads while heater is operating.
Tip over Switch

Assembly

Swivel
Manifold
Tank Collar Bracket
Figure 1
© 2018 Pinnacle Climate Technologies, Inc.
®
ASSEMBLY
Machine
Screws
Regulator
Knob
Fuel Connector Nut
Mounting Bolt Knob
NEVER LEAVE HEATER UNATTENDED WHILE
BURNING OR WHILE CONNECTED TO A FUEL
Model PT-47-TTC:
Tools Needed:
– Medium Phillips head screwdriver.
1. Insert the mounting bolt knob into the tank
collar bracket.
2. Place tank collar bracket on the swivel bracket.
3. Place the plane washer on the tank collar
bracket and then insert the support bolt
(see Figure 2)
4. See Figure 3 on page 9 for determining burner
position options.
Swivel Bracket
Regulator
Knob
Figure 2
Propane Tank Top Heater User's Manual
8
SOURCE
Fuel Connector Nut Tank Collar Bracket
Wing Nut
Plane Washer
Mounting
Bolt Knob