Protemp PT-16-TTC Manual Del Usuario E Instrucciones De Operación página 9

Ocultar thumbs Ver también para PT-16-TTC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PT-47-TTC (Continued):
– To have all 3 burners face front, the plane
washer should be to the right side of tank collar
bracket (see Figure 3).
Figure 3
Connecting Heater to LP Cylinder:
Be sure to read and understand all of the Safety
Information in this manual before connecting the
heater to the LP cylinder. Installation must conform
to local codes and with the Standard for the Storage
and Handling of Liquefied Petroleum Gasses and
ANSI/NFPA 58.
Inspect the hose and regulator prior to each use of
the heater. If there is excessive abrasion or wear,
or if the hose is cut, replace it with the proper
assembly shown in the parts list prior to using the
heater.
Model PT-16-TTC:
1. Be sure that the control knob on the regulator is
in the "OFF" position.
2. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful not
to over tighten.
3. Slowly open the LP cylinder valve.
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE
BURNING OR WHILE CONNECTED TO A FUEL
®
ASSEMBLY
– To have far left burner face back, the plane
washer should be to the left side of tank collar
bracket (see Figure 3).
Models PT-32-TTC / PT-47-TTC:
1. Be sure that the control knob on the regulator is
in the "OFF" position.
2. Line up the slots in the tank collar bracket
with the tank collar ring and slide into place.
Be sure the mounting knob is to the outside,
and tighten.
3. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful not
to over tighten.
4. Slowly open the LP cylinder valve.
Check all connections for leaks using a 50/50
mixture of dish-soap and water. Any bubbles that
appear show a leak. Remove and reconnect the
Connector Nut to the valve.
WARNING
cylinder located within 20 feet of the heater.
9
SOURCE
DO NOT direct the heater dis-
charge towards any propane
Propane Tank Top Heater User's Manual

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pt-32-ttcPt-47-ttc

Tabla de contenido