Heat Sensor; Controls And Features - Monogram 30 Serie Manual Del Propietário

Campana montada en pared
Ocultar thumbs Ver también para 30 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Controls
1. On/OFF Button : Turns both fan and lights
2. Fan – : Pressing the fan decrease (-) button
3. Fan + : Pressing the fan increase (+) button
4. Light – : Pressing the light decrease (-) button
You have the option of changing the factory
Programming
default (or previously programmed) settings for the
settings
On/OFF button.
1. With all functions off, press and hold the On/
2. The control is now in programming mode.
To protect the electronics, this hood is equipped

Heat sensor

with an auto On feature that will automatically
turn on the blower or increase the speed if
excessive heat is detected above the cooking
surface.
4
on to default (or user programmed) settings.
Default settings are FAN medium, LIGHT level
2. See below for details on how to program
the control to your preferred settings. If the
hood is in active mode (fan on and/or lamps
on), when the user presses the ON/OFF
button, all functions will be turned off.
will step the blower down to the next lower
blower speed, looping in this order: BOOST →
HIGH → MEDIUM → LOW → OFF → BOOST...
will step the blower up to the next higher
blower speed, looping in this order: LOW →
MEDIUM → HIGH → BOOST → OFF → LOW...
will step the lamp intensity down to the next
lower intensity, looping in this order: Level 4 →
Level 3 → Level 2 → Level 1 → OFF → Level 4...
OFF button for 3 seconds. The fan speed will
be on medium and the light intensity will be on
Level 2 (or previously programmed settings).
The hood lamps will blink 3 times. Release the
button.
You can set the fan and light settings to your
preferred setting by pressing the Fan +, Fan -,
Light +, and Light - buttons.
nOte: You do not have the option of setting
the fan or lights to OFF.

Controls and Features

Stainless Steel Hood
"Light +"
"Light -"
Light Intensity
Light Intensity
Increase
Decrease
"Fan -"
Speed
Decrease
"Fan +"
Speed
Increase
ON/OFF
Button
5. Light + : Pressing the light increase (+) button
will step the lamp intensity up to the next higher
intensity, looping in this order: Level 1 → Level 2
→ Level 3 → Level 4 → OFF → Level 1...
3. When the desired fan and light settings have
been selected, press the On/OFF button to
store these settings. You have 30 seconds to
complete this task.
nOte: If the control is in programming mode and
30 seconds have passed with no button activity
detected, the control will revert to the last saved fan
and light setting (default or programmed).
Power interruptions will cause the controls to revert
to the factory settings.
When the auto On feature is activated, you may
increase the fan speed but you cannot lower the fan
speed or turn off the blower. The hood will remain in
auto On mode until temperatures have dropped to
acceptable levels. The fan speed will change to the
original user setting when auto On is deactivated.
The auto On feature will always have priority over
the fan speed set by the user.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zv30h

Tabla de contenido