Mount The Rk15Wallo To A Wall - StarTech RK15WALLO Guia Del Usuario

6. On both ends of the front of the horizontal bracket, use a Phillips type screwdriver
to insert two of the assembly screws through the horizontal bracket and into the
vertical rail. Tighten the screws in place.
7. On both sides of the horizontal bracket, use a Phillips type screwdriver to insert two
of the assembly screws through the horizontal bracket and into the vertical rail.
Tighten the screws in place.

Mount the RK15WALLO to a wall

Warning! Remove all equipment from the wall-mount rack before you attempt to
mount it to a wall.
Warning! Wall structures vary and it is important to make sure that the type of
wall structure and mounting hardware that you are using will properly support the
mounted equipment. Failure to do so might result in personal injury and/or equipment
damage. The wall structure should be capable of supporting at least four times the
weight of the mounted equipment.
The RK15WALLO can hold up to 198 lb. (90 kg) in weight.
Warning! If you lack the necessary expertise to attach this product to the wall that
you're using, contact a construction professional to install the wall-mount rack or to
provide specific mounting instructions for your wall structure.
1. Use the four wall-mount holes in the horizontal brackets as a template to mark the
wall where you want to hang the wall-mount rack.
2. Follow the appropriate steps for the type of wall that you're using and attach the
wall-mount rack to the wall.
Instruction manual
6