Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
DESCRIPTION
The NAPA Tire Hardware®
Automatic Bead Seating Tool uses
compressed air to properly seat the
bead on Auto, ATV, and Truck Tires.
Please read the following
instructions below before
proceeding with tool operation.
BEFORE OPERATION
Check that you have received your
NAPA Tire Hardware® Bead
Seating Tool in good condition with
no signs of damage. Please
familiarize yourself with the
components of this product (see
component drawing on the right).
Note: The bead seating tool should
arrive fully assembled except for the
threaded barrel which must be firmly
threaded onto the release valve
assembly before use. Read the
following instructions and safety
information before using this
product.
WARNING:
For your safety it is very important to
please check that the safety insert
clip (16) is securely fastened around
the air release button (18) before
use. This will prevent unintentional
air release from occurring.
16. Safety Inert Clip
18. Air Release Button
FILLING THE BEAD SEATING
TOOL WITH AIR
The bead seating tool can be filled
with air from any general
commercial compressed air source.
Please refer to the tank pressure
information table (on page 5) for
more information on tire type and
suggested tank pressure before
proceeding.
1. Make sure the air release valve is
closed and attach the air supply line
to the PCL connector on the bead
seating tool.
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MAN U AL FOR FUTURE REF ER ENCE.
90-404
AUTOMATIC BEAD SEATER
COMPONENT DRAWING
1.
Air Tank
2.
PCL Connector
3.
Air Intake Valve
4.
90º Bushing
5.
3/4"-1/4" bushing
6.
Pressure Gauge
7.
Safety Release Valve
8.
Automatic Air Release Valve Assembly
9.
Lock Nut
10.
Threaded Barrel
11.
Barrel Flange
12.
Screw
13.
Nylon Hose
14.
Locking Bracket Plates
15.
Bushing
16.
Safety Insert Clip
17.
Screw
18.
Air Release Button
19.
Screw
2
rev. 11/10/11
Publicidad
