Safety Information - Philips WACS7000 Manual Del Usuario

1.6 Safety information

●
Place the set on a flat, firm and stable surface.
●
Keep the system, batteries or discs away from
excessive moisture, rain, sand or any heat
sources, such as heating equipment or direct
sunlight.
●
Place the set in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
●
Never cover the ventilation openings with items
such as newspapers, table-cloths, curtains, etc as
this will impede ventilation.
●
Never expose the set to water dripping or
splashing.
●
Never place objects filled with liquids, such as
vases, on the set.
●
Never place sources of naked flame, such as
lighted candles on the set.
●
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
1. General information
CAUTION
Visible and invisible laser radiation.
If the cover is open, do not look at
the laser beam.
High voltage! Do not open.You run
the risk of getting an electric shock.
The set does not contain any user-
serviceable parts.
Modification of the product could
result in hazardous EMC radiation
or other unsafe operations.
Use of controls or adjustments or
performance of procedures other
than herein may result in
hazardous radiation exposure or
other unsafe operation.
11