Safety Instructions For Maintenance; Assembly; To Attach The Loop Handle; To Assemble The Two-Piece Shaft - Husqvarna 128CD Manual Del Usuario

Ocultar thumbs Ver también para 128CD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not add fuel to the engine in an indoor area. Not
sufficient airflow can cause injury or death because
of asphyxiation or carbon monoxide.
Tighten the fuel tank cap carefully or a fire can
occur.
Move the product at a minimum of 3 m (10 ft) from
the position where you filled the tank before a start.
Do not put too much fuel in the fuel tank.
Make sure that a leak cannot occur when you move
the product or fuel container.
Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an open
flame.
WARNING: Read the safety chapter before
you assemble the product.

To attach the loop handle

1. Attach the loop handle to the shaft in compliance
with the illustration and tighten.
2. Make sure that the loop handle attaches between
the arrows on the shaft.

To assemble the two-piece shaft

1. Turn the knob to loosen the shaft coupling.
215 - 004 - 22.05.2020
Only use approved containers when you move the
fuel or put the fuel into storage.
Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
Clean the product before long-term storage.
Remove the spark plug cable before you put the
product into storage to make sure that the engine
does not start accidentally.

Safety instructions for maintenance

If you cannot adjust the idle speed to make the
cutting attachment stop, speak to your service
center. Do not use the product until the product is
correctly adjusted or repaired.

Assembly

2. Move the locking/release button (A) into the guide
recess. Push the attachment into the coupler until
the locking/release button sets into the primary hole
(B).
3. Insert the shaft into the shaft coupling. The button
must go through the hole.
Note: If the attachment does not go fully into the
upper shaft, use a small screwdriver to push the
internal drive shaft deeper into the tube. It can be
necessary to turn the screwdriver while you push.
4. Make sure that you fully tighten the knob before you
operate the product.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

128ld

Tabla de contenido