Start-Up And Operation - S&P SAHARA 1503 Instrucciones De Uso

- Children must be supervised to avoid contact with the product.
- Only for internal use
ASSEMBLY
For transport reasons, the wheels are not fitted and are supplied separately within the
packaging.
1.- Remove the wheel set from the packaging.
2.- Mount the four wheels on the two metal supports. Be sure to put the security screws in
the position shown in Figure 1. Properly tighten all screws to prevent loosening.
3.- Overturn carefully the radiator on a carpet or other soft surface, to avoid damaging the
appliance.
4.- (Fig.2) Insert the locking ring into the hole in the base of the wheel. Place the wheel
under the radiator. Once properly seated, place the ring inside the other support hole. Fix the
ring against the support by butterfly screw.
5.- Check that the wheels have been mounted correctly.
6.- Put the radiator in vertical position and wait about 15 minutes before connecting the
device in the electrical ductwork, to ensure that all the oil inside has drained into the base.

START-UP AND OPERATION

1.- Before connecting the device to the mains, check that the grid voltage coincides with that
shown on the data plate.
2.- Turn the thermostat control (Fig. 3 C) clockwise to its maximum position.
3.- Select the desired power setting using the two switches with light indicator (Fig.3 A-B).
SAHARA series models have 3 operating options, with different heating outputs:
Heating outputs
II + I HIGHT
II MEDIUM
I LOW
4.- When the room reaches the required temperature, rotate the thermostat control anti
clockwise until it clicks and turns off the device.
When the thermostat control is in this position, the appliance will switch on and off
automatically to keep the pre-selected comfort temperature constant.