MIDI Pedalboard PK-9
Parameter mode
4.
Parameter mode
Parameter mode lets you make various settings for this unit.
Basic operation in Parameter mode
Here's the basic procedure for making settings in
Parameter mode.
1.
Simultaneously press the [CONTROL 1] and
[CONTROL 2] pedals.
The [CONTROL 1] and [CONTROL 2] indicators flash.
The PK-9 is now in Parameter mode. The abbreviation
of the first parameter (or of the last parameter you
selected since switching on the PK-9) flashes.
2.
Press the [CONTROL 1] or [CONTROL 2]
pedal to select the desired parameter.
For details on each parameter, refer to "Parameter
settings" on p. 15.
3.
Press the Hold pedal to confirm.
The display shows the value.
4.
Press the [CONTROL 1] or [CONTROL 2]
pedal to change the value.
5.
Press the Hold pedal to confirm the value
and leave Parameter mode.
14
trn
Saving the settings (Save function)
When the PK-9's power is turned off, it will return to its
default settings. However, if desired, you can save the
following settings so that they will be remembered even
after the power is off.
Parameter settings that are saved
Transpose
Octave
Control 1 Assign
Control 2 Assign
Foot Switch Left Assign
Foot Switch Right Assign
Retrigger
Velocity
Touch
Portamento Time
Octaver Value
Pedal Assign
Auto Off
MIDI Transmit Channel
1.
Simultaneously press the [CONTROL 1] and
[CONTROL 2] pedals.
The [CONTROL 1] and [CONTROL 2] indicators flash.
The PK-9 is now in Parameter mode.
2.
Press the [CONTROL 1] or [CONTROL 2]
pedal to select the "SAv" parameter.
SAv
3.
Press the Hold pedal to confirm.
The display shows "ok" and the PK-9 leaves Parame-
ter mode.
Page
15
15
15
15
15
16
16
16
16
16
16
16
16
15