Foot Switch Right Assign; Retrigger; Velocity; Touch (Velocity Curve) - Roland PK-9 Manual Del Usuario

MIDI Pedalboard PK-9
Parameter mode

Foot Switch Right Assign

Display
S r
This parameter allows you to assign a function to the
footswitch on the right side of the expression pedal.
See "Foot Switch Left Assign" for an explanation of
the available settings.
NOTE
If you connect the PK-9 to an instrument of the Roland
VK-series, the CC18 message controls the "Rotary Slow/
Fast" parameter, while the CC19 message controls the
"Rotary Break Speed" parameter.

Retrigger

Display
rEt
This parameter is only available while the PK-9 is in
Mono mode. To select that mode, you first need to
assign the "Mon" function the [CONTROL 1] or
[CONTROL 2] pedal and then activate that pedal. See
also "CONTROL 1 Assign" and "CONTROL 2 Assign" on
p. 15.
When "Retrigger" is on, some special effects can be
obtained. In Mono mode, the pedalboard is mono-
phonic: if you press two pedals simultaneously, only
the last note played will sound. When that note is
released, the previous note will sound, so a pleasant
alternating effect can be obtained.

Velocity

Display
vEl
If this parameter is on, your playing dynamics are
translated into MIDI velocity values (1~127). If you
choose a fixed value (1~127), the PK-9 transmits all
notes with that value.

Touch (velocity curve)

Display
tCh
The PK-9's pedals are velocity sensitive. If necessary,
you can select a different velocity curve to suit your
playing style.
16
Value Default
C18, C19, Por C19
Value Default
Off, On Off
Value Default
On, 1~127 On
Value Default
SFt (soft), Med (Medium), Med
hrd (hard)
NOTE
The "Touch" setting is ignored while "Velocity" is set to a
value (1~127).

Portamento Time

Display Value
0~127
Por
"Portamento" means that the pitch doesn't change in
clearly defined steps: it produces glides from one
note to the next. Use this parameter to specify the
speed at which those glides are carried out. The
higher the value, the slower the transitions.
NOTE
If the receiving MIDI instrument doesn't support this
parameter, this setting will have no effect.

Octaver value

Display Value
–4~–1
oCv
This parameter allows you to specify the pitch of the
note that is added while the "oCb" function is active.
See "CONTROL 1 Assign" on p. 15 for details.

Pedal Assign

Display Value
"CUt" (Cutoff), "rES"
Ped
(Resonance),
"Pbd" (Pitch Bend Down),
"PbU" (Pitch Bender Up),
"Mod" (Modulation),
"hLd" (Hold),
"voL" (Volume),
"PAn" (Panpot),
"C16" (Control Change
16), "C17" (Control
Change 17),
"C18" (Control Change
18), "C19" (Control
Change 19)
This parameter allows you to assign a function to the
pedal you connect to the EXTERNAL PEDAL socket.

Auto Off

0ff, 10, 30, 240
Aof
This parameter allows you to specify how long the
PK-9 should wait before switching itself off while
you are not using it. If you don't want the power to
turn off automatically, select "Off".
Default
50
Default
–1
Default
"hLd"
(Hold)
240