Adjusting The Screen Brightness; Troubleshooting Guide - essentiel b RRVP-100 Instrucciones De Uso

Stop and reactivate the alarm for the next day:
When the alarm sounds, press the button
automatically reactivate it the next day. The alarm activation indicator light on the
display stays on.
To cancel the alarm permanently, press the button
left of the time disappears instantly.
You can press the button
alarm time.

Adjusting the screen brightness

By default, the radio alarm clock is set to an intensive screen display. To decrease
or increase the light intensity, repeatedly press the Snooze/Dimmer button.
26
V.1.0
using the device
to stop the buzzer or radio and
. The indicator light to the
at any time for a reminder of the

troubleshooting guide

Before contacting your retail store service desk, check the following.
Problem Possible cause
No power The device is not plugged in.
No sound The volume is set to minimum.
The station has not been tuned
correctly.
Poor FM reception The FM antenna is incorrectly
positioned.
There is interference from other
electrical devices such as
microwave ovens, TVs, etc.
The alarm is not enabled or is not
set properly.
The alarm doesn't
work
The clock is not set.
The alarm time has been set but
not activated. The indicator light
is not illuminated to the left of
Alarm function is
the time.
The volume is set to minimum.
Solution
Plug the device into an
appropriate wall socket.
Increase the volume by using
and
the buttons .
Fine-tune the FM station setting
by pressing and holding the
button and using the
and
buttons .
Deploy and point the FM
antenna in another direction.
Move the radio alarm clock
away from potential sources of
interference.
Refer to the paragraph "Setting
the alarm".
You must set the clock before
setting the alarm.
Press the button to activate
the alarm and display the
indicator light.
Increase the volume by using
and
the buttons .
27
V.1.0
troubleshooting guide