Conformity And Approval; Inserting Batteries; Connecting The Microphone - Monacor JTS PT-36BG2/5 Manual De Instrucciones

2 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only Protect
it against dripping water and splash water, high
air humidity and very high or low tempera-
tures (admissible ambient temperature range:
0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated, or if it is
not repaired in an expert way
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment
3 Applications
Combined with the JTS receiver US-36G2 /5, this
pocket transmitter (including lavalier microphone)
creates a wireless audio transmission system
(506 – 542 MHz) Just like on the receiver, the
transmission frequency can either be selected
from one of the 6 preset groups or directly set
in steps of 25 kHz

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the pocket transmitter PT-36BG2 /5 complies
with the directive 2014/53/EU The EU decla-
ration of conformity is available on the Internet:
www jts-germany de or www monacor com
The pocket transmitter may be operated in the
following countries:
DE
In the Federal Republic of Germany, the pocket
transmitter requires a frequency assignment
(for which a fee is charged) In other countries,
it is necessary to apply for a corresponding ap-
proval Prior to operating the wireless transmis-
sion system outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
national authorities can be found via the following
Internet address:
www cept org
 ECC
 Topics/Info
 SRD* Regulations and indicative list of equip-
ment sub-classes
 EFIS and National Frequency Tables
* Short Range Devices

4 Inserting Batteries

For power supply, two 1 5 V batteries of size AA
are required
•
Only insert batteries of the same type and al-
ways replace both of them
•
If the pocket transmitter is not in use for a
longer period of time, always remove the bat-
teries as a precaution to prevent damage due
to battery leakage
1) To open the battery compartment, slightly
press the marking on the cover (6) and push
the cover downwards
2) Insert the batteries with the positive and neg-
ative poles as indicated in the compartment
3) Close and lock the cover
Never put batteries in the household
waste; always take them to a special
waste disposal, e g collection container
at your retailer

5 Connecting the Microphone

Fasten the microphone provided to its clip, and
then connect the microphone to the microphone
input (2) (To disconnect and remove, press the
black button to unlock the mini XLR inline jack )
Attach the clip to your clothes (e g tie), as close
to your mouth as possible
Instead of the microphone provided, it is also pos-
sible to use another JTS microphone equipped
with a 4-pole mini XLR connector
9