Setting The Transmission Frequency; Setting The Frequency Manually - Monacor JTS UF-10R/12 Manual De Instrucciones

c) Turn the knob to select:
Line
for connection to a line level input
Mic.
for connection to a microphone input
d) Press the button SETUP to save the setting.
The main menu reappears.
e) To deactivate the menu, press the button
EXIT (8) or to change the setting, turn the
knob PUSH / CONTROL and select the corre-
spond ing menu item.
2) If the antenna amplifiers UB-900 / 2 have been
connected to the antenna jacks (13), select the
ON
setting via the menu item
if not, select the setting
Antenna Power
ON
OFF
3) Via the menu item
can be entered (10 characters max.) which will
appear on the display (e. g. UF-10R in fig. 2).
When several receivers are used, this will make
it easier to distinguish between the receivers
and to identify them. After the menu item
UF-10R
has been called up, the first character
position is selected:
User Name
UF-10R
Char:1/10
Turn the knob PUSH / CONTROL to set the
desired character. Press the knob to go to the
next character position. After setting the name,
press the button SETUP to save the setting.
4) If it is difficult to read the display, call up the con-
trast setting via the menu item
Setup Contrast
Turn the knob PUSH / CONTROL to set the con-
trast. Then press the button SETUP to save the
setting.
Antenna Power
OFF
.
Fig. 5
User Name
, a unit name
Fig. 6
Contrast
5/7
Fig. 7

6.2 Setting the transmission frequency

Before switching on the corresponding transmitter
(UF-10TB / 12 or UF-12TH / 12), set the receiver to
an interference-free transmission frequency. There
are various methods to do this:
1. The transmission frequency can be adjusted man-
ually between 624.000 MHz and 693.975 MHz
(chapter 6.2.1).
2. For operating several audio transmission sys-
tems at the same time (chapter 6.2.2), there are
12 groups with up to 60 channels in each group
( table on page 36, 37). In ideal conditions,
;
up to 40 channels from a group can be used for
audio transmission at the same time.
The scan function can be used to determine the
channels being used for transmission by other
systems (chapter 6.2.3). These channels will be
skipped during channel selection.
3. Preferred frequencies can also be stored in
your own six frequency groups (chapter 6.2.4),
e. g. when operating several audio transmission
systems in varying locations.

6.2.1 Setting the frequency manually

1) Call up the frequency setting via the menu item
Frequency
Setup Frequency
634.375 MHz
G: 2 CH:11
2) Turn the knob PUSH / CONTROL to set the fre-
quency in steps of 1 MHz.
3) For fine adjustment in steps of 0.025 MHz, press
the knob so that the digits after the decimal point
are highlighted. Then turn the knob. If the fre-
quency is identical to the frequency of a channel
.
in the group, the group number and the channel
number will be indicated in the bottom line.
4) Press the button SETUP to store the frequency
selected.
of the main menu.
Fig. 8
15