Preface; Getting To Know Your Binoculars; General Instructions; Attaching The Carrying Strap - MINOX BN 7x50 DCM Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preface

Congratulations to the purchase of your MINOX
BN 7x50 DCM nautic binoculars, with a fully integrated
digital compass. As with all MINOX products, these in-
novative binoculars adhere to the old traditions of our
establishment in combining high functionality, reliability
and comfort with the outstanding quality of robust, de-
pendable mechanics into the smallest amount of space.
The MINOX BN 7x50 DCM was specially constructed
for use in water sports and nautical activities. Not only
for observation and navigation at sea, the MINOX BN
7x50 DCM is a reliable and useful tool for any water
sports enthusiast or even on land. The fully integrated
digital compass allows for an especially ergonomic and
intuitive operation.
These instructions should help you to appreciate the full
range of functionality and to apply these to the fullest.
Please take a moment to read the following safety and
operational guidelines, and get to know your new
MINOX BN 7x50 DCM binoculars before putting them
to use.
36
Please note: Disposing of electrical and
electronic devices
(valid in the EU, as well as other European countries
with different waste collection systems)
This device contains electrical and electronic com-
ponents and should not be disposed of in domestic
waste. Instead, please bring this device to the local
or community recycling center, usually set up for this
express purpose and is usually free-of-charge. The de-
vice contains a changeable battery – when the battery
is empty, please remove it and dispose of according to
regulations. You can find out more information about
this topic at the local council, waste disposal firm or
in the shop where you purchased these binoculars.

Getting to know your binoculars

Place your MINOX BN 7x50 DCM vertically on a flat
surface in front of you, with the objective lenses down.
The eyepieces with their twisting rubber eyecups (1)
should be upward with the control buttons facing you.
To the right, you will see the Up / Down navigation but-
tons (3). To the left, you will see the On / Off button (10)
surrounded by the mode dial (11). Below that, you will
find the memory button (8) to save and confirm readings
and settings. At the center of the two binocular halves,
is the hinged construction to allow for an individual
setting to compensate for the interpupillary differences
between the user's eyes. To the right and left of the
binoculars are the carrying strap brackets (9). At the
bottom and between the objectives, you will find the
tripod mounting thread (6) with its screw-on cap (7).
This thread, together with the MINOX tripod adapter,
allows for the mounting of your MINOX BN 7x50 DCM
to a tripod. To the right of the tripod thread, you will find
the battery compartment (4) with its T-screw cap (5).
An overview of the product highlights:
-
Binoculars with high grade porro prism system
-
Fully integrated digital compass with many
other features
-
Precise, automated tilt compensation
-
Exchangeable eyecups
-
Single ocular focus adjustment
-
Floatable and water tight down to
1 meter / 3.28 feet
-
Non-fogging and filled with nitrogen gas
-
Robust housing with non-slip rubber armoring

General instructions

for BN 7x50 DCM

Attaching the carrying strap

A neoprene carrying strap is included in the delivery of
your MINOX BN 7x50 DCM, which helps to keep your
binoculars afloat in the case that they should fall into
the water. To avoid loss or damage to the binoculars if
they should fall, we suggest strongly to use the strap at
all times when using your MINOX binoculars.
Thread the strap through one of the brackets (9) on your
binoculars. Pull the end of the strap back towards the
buckle and then through the bottom of the buckle. Re-
peat this procedure for the other side of your binoculars.
After you have successfully attached the carrying strap,
you can adjust it to your preferred length.

Attaching the eyepiece caps

Attach the eyepiece caps by threading the carrying
strap through the loop (without slit) before the strap
is attached to the binoculars. It is highly advisable to
cover the eyepieces when the binoculars are not in use
to protect the ocular lenses from foreign substances like
rain, dust or sand. When using the binoculars, the caps
will hang on your carrying strap to avoid loss and will
not get in the way.
37

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bn 7x50 dc

Tabla de contenido