HAEGER Expert Trim HC-WG3.011A Instrucciones De Uso página 6

English
charged for 2-3 hours, but it shouldn't be charged for long time, or it will shorten the
operation life of the batteries.
There are two methods to charge the appliance.
Direct connection – connect the adaptor plug directly into the body.
Using charging stand - connect the adaptor plug directly into the charging stand
and then put the appliance into the stand.
1. Ensure the product is switched off.
2. Place your hair clipper into the charging stand, connect the charging adaptor to
the product and then to the mains. The charging indicator will light up.
3. The indicator will be turn green colour when the charging is finished, the
machine will stop charging.
4. Your hair clipper cannot be overcharged. However, if the product is not going to
be used for an extended period time(2-3mouths), unplug it from the mains and
store. Fully recharge your hair clipper when you would like to use it again.
5. To preserve the life of your batteries, let them run out every six months then
recharge for 3 hours.
Notes: It is normal that the outer and transformer of electric hair clipper is slightly
heat.
O
PERATION INSTRUCTIONS
1. Your hair clipper was examined to ensure that the blades were oiled and aligned
before leaving the factory.
2. Add a few drops of oil to the blades, turn clipper on for a few seconds before
trimming and then turn off. Use a damp cloth to wipe the clipper body to avoid
that the oil spatter on people's hair.
3. Please always keep the clipper clean and usually drop oil to lubricate the blades.
R
ECOMMENDATIONS
•
We recommend that the hair should be DRY when cutting with the clipper for
better control over the amount of hair cut.
•
Use SHORT STROKES. Do not complete a whole side with one stroke.
•
Remember to comb the hair frequently as you are cutting it.
•
To cut the HAIR EVENLY, allow the clipper ADVANCE SMOOTHLY through the hair.
Do not attempt to force it.
4 Instructions manual