KitchenAid 720-0826 Instrucciones De Instalación Y Manual De Uso Y Cuidado página 22

7. Reinstall the orifice support and supply pipe and tighten the
nut with a 24 mm wrench.
8. Reinstall the spider guard, access cover, and wind baffle.
Change the Side burner Orifices
1. Use a wrench to remove the side burner orifice brass
connector with flex line end to side burner tube.
A. Side burner flex end
2. Use 6 mm socket wrench or 6 mm nut driver to remove the
orifice. Replace with the Natural gas orifice.
A. Orifice
IMPORTANT:
Check that the orifice is properly installed inside of the valve.
3. Reinstall side burner, tighten the side burner orifice brass
connector and side burner tube by using a wrench.
4. Open the manual shutoff valve in the gas supply. Then valve
is open when the handle is parallel to the gas pipe.
22
5. Test all connections using an approved noncorrosive leak-
detection solution. Bubbles will show a leak. Correct any
leak found
Record Conversion
1. The appliance nameplate is located inside the grill
cabinet on the left –hand cabinet side. With a
permanent marker, check the box next to "Natural
A gas" and mark through "LP-Propane."
2. In the last page of the Use and Care Guide, write;
"Converted to Natural Gas." Also record the conversion
date and the technician/company that performed the
conversion.
Note: Place LP gas parts in plastic parts bag for future use and
keep with pack containing literature.
Adjust High Flame Setting Screw
When converting from LP to Natural gas, you will need to
adjust the high flame setting screw for ideal burner flame
height.
1. Remove each control knob for the main burners and side
burner.
A
2. Use a small precision flat-blade screwdriver to turn the
high flame set screw counter-clockwise, approximately 90
degrees.
3. Check that burner operates at the new high flame setting. It
may be necessary to adjust the screw setting slightly more
to get the ideal burner flame height.
A. Closed valve
B. Open valve