Outer Cleaning - IARP B-ICE N Manual De Instrucciones De Empleo Y Manutención

INNER CLEANING
The appliance makes the automatic defrosting.
We recommend a manual defrosting in the tanks (in the upper tank on B-ICE N/P) when the frost
layer is too thick
Proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature.
2. Switch off the mains system by using switches (1) and (2) (see controls) and unplug the unit.
3. Put below a tray for draining water and remove the external and internal draining plug.
4. Leave the glass covers open; before cleaning the tank the inside temperature must be the same as
the ambient; clean and dry the tank's walls with a soft cloth, using neutral soap.
5. Subsequentely,replace draining plug, plug in again and wait till the appliance reaches the right
temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
B-ICE
Warning! Do not use water jets for cleaning: this can damage the electrical
parts.
Warning! Do not use mechanical appliances or other means to speed up the
defrosting process, other than those recommended by the manufacturer.

OUTER CLEANING

For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
MINI B-ICE
-20-