Publicidad
Idiomas disponibles
Idiomas disponibles
Label of individual components
1
2
1. Mouthpiece and Mouthpiece Slot
2. Power Button (on the back of the device)
3. Air Outlet (always keep this part unblocked)
4. Battery Compartment Cover (on the back of the device)
This way you receive results that are as accurate as possible
A) Wait at least 15 minutes after your last sip of alcohol. Do not
eat, drink or smoke during that time.
B) Do not open the casing.
C) Do not keep the breathalyzer in cold, hot, moist or badly
ventilated places.
D) Keep the breathalyzer out of the reach of children.
E) Conduct three inlet tests after long storage before
conducting the actual alcohol test.
F) Do not drop the breathalyzer.
G) Change the battery if it is depleted. Diminished battery
capacity leads to incorrect test results.
H) Do not conduct tests in loud (sound waves disrupt the
sensor), drafty or poorly ventilated places.
I) After a test result of 1.00 per mill (per mill = EU setting) / 0.10%
BAC (% BAC = US setting) / 0.50mg/L (mg/L = UK setting) or
higher the sensor needs rest time. In this case wait at least
three minutes before starting the next test.
J) Do not conduct tests in very cold, very hot or an
unventilated, smoky ambience.
17
K) Store the breathalyzer in a way to avoid penetration by dust
or liquids.
L) Blowing too hard may cause damage to the sensor as saliva
flows into it.
3
Preparation for the test
1. Installing a battery
Push up the bottom part of battery cover to open it. Install an
AAA battery in the battery compartment while taking note of
4
the battery polarity. Insert bulging parts of the battery cover
into the slits and then push down its cover.
2. Inserting a mouthpiece
Insert a mouthpiece into the slot on the side of the alcohol
tester. Ensure whether it securely fits or not. It is highly
recommended to use an extra mouthpiece for every test for
sanitary reasons.
3. Installing the ACE AFM-5 app
Download the ALCOFIND app from App store (iOS) or
Google Play Store (Android). Note the minimum smartphone
requirements: Either an iPhone 4S running iOS 7 and above
or Android devices running OS 4.3 and above. Open the app.
Select language and unit, then press OK button.
NOTE: For changing language and unit later, go to setting at
the bottom menu.
Operation with App (App mode)
Step 1. Open the app.
NOTE: Bluetooth must first be switched on in order to connect
to the ACE AFM-5. (Go to the settings on your smartphone and
turn on Bluetooth.)
Step 2. To turn on the ACE AFM-5, press and hold Power button
for a second until the Blue, Green and Red LEDs appear on the
device as shown in the picture below.
Step 3. The Blue LED will blink during pairing process. If pairing
is successful, Green and Red LEDs will appear on the device
and the screen on your smartphone will show „START TEST".
Tap „START TEST" on your smartphone (or press Power button
on the ACE AFM-5).
18
Publicidad
