Technical Description; Installation; Electrical Installation - Dometic SKYSCREEN POWERED Instrucciones De Montaje

Skyscreen Powered
6

Technical description

The blinds are available for a connection to 12 Vg or 24 Vg.
The motor can be controlled using:
• Switches
• AP Remote control
• Central control systems
The number on the product label in the head rail indicates the blind type.
The dimension drawings show the required measurements for fixing with surface
covers or concealed with the boat headlining (fig. c, page 9).
7

Installation

!
WARNING! Risk of injury
Disconnect the power supply before you begin and ensure that it can not be
reconnected until installation has been completed.
7.1

Electrical installation

A
NOTICE! Risk of damage
• Ensure cables are not damaged during installation.
• Ensure that a 12 V or 24 V power supply line is available for the drive (rated
power 13.2 W) at the point of installation.
• Ensure that the power supply line is suitably arranged and protected.
• Ensure that routings of cables through walls or bulkheads are protected
and insulated by appropriate bushing, grommets or cable conduits.
• Secure all cables to prevent any contact with moving parts.
Proceed as follows:
➤ Decide on the routing of the motor wire (fig. 2, page 3).
➤ Check the voltage of the blind (see cable label).
➤ Choose a location for the control device (such as switch or remote control)
which must be installed in a visible location.
➤ Connect the blind according to the circuit diagram:
– Manually switched blinds (fig. 6, page 5)
– Remotely controlled blinds (fig. 7, page 6)
– Other control system (fig. 8, page 6)
EN
Technical description
15