Cover Fitting (Optional); Operation - Dometic SKYSCREEN POWERED Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
Skyscreen Powered
7.3

Cover fitting (optional)

➤ Proceed as shown (fig. 5, page 5).
8

Operation

A
NOTICE! Risk of damage while driving
Only for boats and yachts: If the blind is fitted beneath an open sunroof,
then the blind should be stowed when driving at more than 10 knots or with a
sea state of more than moderate, because this can damage the blind. Parts that
come loose may injure people in the vicinity.
I
NOTE
• When operating the blind using switches or an automation
system: If the movement direction is reversed too quickly, the motor might
not detect the polarity change and will just stop. To prevent this, the power
must be off for at least 0.5 seconds before the movement direction is
reversed.
• When the motor is stopped the power consumption falls to 8.5 mA. After
approximately 4 minutes the motor automatically switches off.
• Only if operated by switches: When operating the blind with switches
each switch operates each blind independently.
• Only if operated with the AP Remote control: When operating the blind
with the AP Remote control each blind is independently operated via sepa-
rate channels on the remote control.
• Each blind can be stopped in any position.
• When operating the blind with an automation system, the operation is
dependent on the programming of the control interface.
• The blind automatically stops
– when the blind is fully deployed,
– when the blind is fully stowed
– if the blind hits an obstruction (including the other moving rail)
EN
Operation
17

Publicidad

Tabla de contenido
loading

Tabla de contenido