Worx WG190 Manual De Uso página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

only charge the Li-Ion battery also supplied.
Do not use another battery charger.
2. CHARGiNG youR BATTERy PACk
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine will switch off by means of a
protective circuit: The trimmer head no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. To REmoVE oR iNSTAll BATTERy
PACk (See Fig. d1, d2)
Depress the battery release button to release
battery pack from your trimmer (See Fig. D1).
After recharging, insert the battery pack into
trimmer's battery port (See Fig. D2). A simple
push and slight pressure will be sufficient until
a click is heard.
NoTE: when removing the battery pack,
hold it firmly to avoid dropping and injury.
4. BATTERy STATuS lEd'S (See Fig. E )
NoTE: The Status lEd's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
imPoRTANT:
when only one light is illuminated,
your battery is overly discharged, even
though the trimmer may still be capable
of cutting grass. Continuing to operate
your trimmer with the battery in this
discharged condition may reduce the life
and performance of your battery.
5. SAFETy oN/oFF SwiTCH
Your trimmer has a Lock OFF switch (2) to
13
Grass Trimmer/Edger
"
) are illuminated, the
) is illuminated,
prevent accidental starting. Depress the Lock
OFF switch and the Variable speed control (4)
to start your trimmer. To switch off, just release
the on/off switch.
wARNiNG! The cutting head
continues to rotate after the trimmer
has been switched off; wait until it has
completely stopped then lay down the
tool.
6. VARiABlE SPEEd CoNTRol
Your machine is fitted with a Variable speed
control (4):
Lower speed–Used for basic light trimming of
short grass
Higher speed–Used for tough over grown
area's of long grass
7. AdJuSTmENT oF AuxiliARy HANdlE
(See Fig. F)
Release the auxiliary handle locking clamp,
move the the auxiliary handle to the most
comfortable and balanced position. Close the
clamp to tighten the handle.
NoTE: make sure the handle is firmly
secured in place.
opErATIoN
wARNiNG: Always wear the eye
protection. Never lean over the
trimmer head. Rocks or debris can ricochet or
be thrown into eyes and face and cause
blindness or other serious injury. When
operating unit, check for the following:
Wear eye protection and heavy clothing. Hold
front handle with one hand and auxiliary
handle with the other hand. Keep unit below
waist level. Work only from your right to your
left to ensure debris is thrown away from you.
Without bending over, keep line near and
parallel to the ground (perpendicular when
edging) and not crowded into material being
cut.
wARNiNG: make sure that line is
fed out before operation. make
sure motor is up to full speed before
trimming
wARNiNG: use only 0.08"(2.0mm)
diameter cutting line. Other sizes of
11
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido