Overview Of The Components - HAEGER Thermal Smart TE-100.001A Instrucciones De Uso

are occupied by persons not capable of leaving the room on their
own, unless constant supervision is provided.

Overview of the components

1. Display control
3. Fins
5. Bottom support foot
Installation
A. - Foot assembly
Before using the heater, the feet must be fitted to the unit.
1 - As shown in the right figure,
align the holes of the support-
ing screw with the holes of the
heater body.
2 - Finally use 2 screws (1 for each
hole) to lock and tighten the
feet.
B. - Wall assembly
Please note that the product must be installed at least 15 cm from the floor and
50 cm from the ceiling.
1 - Measure the distance between the two wall hanging holes A and B on the
back of the appliance.
2 - According to the measurement size, drill two 8mm diameter holes in the wall
and then insert the provided anchors in the holes.
Note: Before drilling, make sure that there are no wires or pipes located in the
wall to prevent damage.
3 - Take the long screws out of the accessory bag and fix them on the wall, screw
head exposed 5~10mm.
4 - Then hang the square wall-mounting buckle on the back of the heater in the
wall rivet.
5 - After the product is hung on the wall, it should be pushed to the right so that
the wall rivets fall into the product's long bar fixing position.
Instructions for use
2. Air outlet
4. Main power switch (back)
English
3