Setting The Time And Date - HAEGER Thermal Smart TE-100.001A Instrucciones De Uso

English
Operating Instructions
Turning on main power
Plug in the power cord and turn on the main power
switch. The buzzer sounds once shortly. The whole unit is
in the power supply state. The LCD backlight flash briefly
go on and then remain off, indicating that the whole unit
is in the standby mode.
Power On
Press button, the buzzer will beep once, the temper-
ature bar will show the current room temperature, the
heating power level bar will display the low-level symbol,
and the whole machine will start heating with the low-
level heating power. At the same time, the LCD backlight
is on and the unit enters the power-on setting mode.
Shut down
Press at any time when the unit is powered on without screen lock, the buzzer
will beep for a short sounding, the whole machine will stop running.
Note: If you pull the plug, then insert the plug again, the machine reset to default
state.

Setting the time and date

After power on, set the current time and week:
1. Press for 3 seconds, and the number in the week's
column, start flashing. (Monday to Sunday are repre-
sented as 1-7).
2. Select the week corresponding to the current date
pressing
onds.
3. The hour numbers in the time display column begin to
blink, and the time corresponding to the current time
can be set by the
can set it to 18 and press
6
or , and then press it again for 3 sec-
. If the current time is 18:30, you
again for 3 seconds to
Instructions for use