Dometic GROUP Waeco MagicSpeed MS880 Manual De Diagnóstico página 20

Ocultar thumbs Ver también para Waeco MagicSpeed MS880:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
Setting the sensitivity
NOTE
I
If you hear more than two signals, repeat the procedure.
➤ Drive the vehicle at a speed of 70 km/h to allow the PPM and GAIN para-
meters to be set automatically.
➤ Press the SET button.
✓ The cruise control switches itself on.
If the cruise control does not take on the speed gently or the save value is not
applied:
➤ Press the SET button again to increase the value or
➤ ... press the RES button to decrease the value.
✓ You will hear a signal each time you press the button.
The current value is indicated by the number of beeps (3 – 14 beeps). The
factory setting is 5 beeps.
➤ Apply the brake to save the set values (PPM and GAIN).
✓ Normally, your cruise control should be ideally preset for your vehicle.
➤ Quit setup mode ("Quitting setup mode" on page 23).
➤ You can now use MagicSpeed MS880.
NOTE
I
If, during operation, you notice that the vehicle reacts too slowly or
too suddenly, or the speed is not being regulated correctly, you
must set the control sensitivity manually (see "Setting the control
sensitivity manually (GAIN mode)" on page 22).
20
MagicSpeed MS880
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido